Adjusting Frequency And Phase; Making A Checkerboard Pattern With Paint - Planar m40L Installation Manual

Adjusting Frequency and Phase

Frequency and Phase are mostly adjusted for computer sources and must be made
using the computer that has, or will have, program content. Although Frequency and
Phase can also be adjusted for component sources, it is not usually necessary.
If you press the
and Phase is usually good enough. (See "Auto Setup Options" on page 59.) If
automatic adjustment is not good enough, adjust it manually. If the image shows
vertical banding, adjust the Frequency. (See "Adjusting Frequency Manually" on
page 32) If the image has noticeable horizontal streaks moving through the image,
adjust the Phase. (See "Adjusting Phase Manually" on page 32)
Note:
results with something that has a lot of changes, such as a checkerboard pattern.

Making a Checkerboard Pattern With Paint

You will need to display a checkerboard pattern from the source computer. You can
make one with the Windows Paint program.
Note:
your desktop. Typically it can be found in the Accessories folder.
1
2
3
4
5
6
7
button on the remote, the automatic adjustment of Frequency
SETUP
Auto Setup Options rely on the content displayed on the screen. You will get best
The location of Paint with vary depending on what version of Windows you have on
Choose Image > Attributes to open a dialog box.
In the Units section, choose Pixels. In the Color section, choose Black and white.
Set the Width and Height in pixels to match the native resolution of the Planar
display.
When you click OK, the program gives you a warning about losing color. Click Yes.
At the bottom of the window, click on the checkerboard pattern. This is the 9th
box from the left on the bottom row.
Choose the paint bucket icon and click in the picture area. It will fill
with a checkerboard pattern.
Save this picture as a bit map (.BMP) file to the hard drive so you can
use it again.
m40L/m46L Installation Guide
Adjusting Frequency and Phase
31