Baud Rate; Serial Port Status; Controlling With Rs232 Commands - Planar m40L Installation Manual

Baud Rate

Must be the same as that used by the controlling computer. The baud rate is not
automatically set, as it is with modem communications. It must be manually set here
and at the computer to match each other.
Note:

Serial Port Status

To view RS232 port status, press
of the serial port that has had the most recent activity. To view the status on a
different serial port, use the arrow key.
Ser ial Port Sta t us
<ENTE R> to clea r
Co m m an ds R ec eiv ed
Re pl ie s S en t
La st P ack et Ty pe
La st P ack et A d dr ess
By te s Rec ei ve d
By te s Sen t
UA RT Fra m ing Errors
UA R T Ov er fl ow E r ro rs
The

Controlling With RS232 Commands

The RS232 protocol - the "rules" for controlling displays with RS232 commands - are
described in a separate document. See "Accessing Planar's Technical Support
Website" on page 89 to see how to get to the web page. Then look for m40L/m46L
and under that the RS232 Guide.
For firmware upgrades, you don't need to adjust the baud rate.
. ..115 , 111, 10 8, 117, 1 05 , 111 , 11 0, 63 , 1 3
.s t -- 1? .s t -- 2? .s t -- 3? .l c d .v er ti c a l -r e s ol ut i on? .
SERIAL PORT STATUS
m40L/m46L Installation Guide
twice on the remote. You will see the status
MONITOR
3 4
3 4
O p e r a ti o n
N ot Ad d res se d
92 1
77 3
4
0
M o s t R e c e n t
menu provides diagnostic information for the serial port.
Serial Port Status
73