Planar m40L Installation Manual page 96

If your screen shows black or a test pattern
Do This
3 Press on the remote
MENU
until the
MAIN MENU
appears.
4 Ensure the power cable is
connected, the power
switch is ON and the front
LED is illuminated.
m40L/m46L doesn't respond to remote control
Possible Cause
Power is not on
Remote batteries are dead or improperly
installed
Remote was not aimed at the IR receiver
Something is blocking the IR receiver
Your installer or service provider has disabled
the remote control
86
Result
The "source absent" pane is
visible
The source absent pane is
not visible
Confirm that the power cable is connected and
the power switch is on and the front LED is
illuminated.
Replace or reinstall batteries.
The IR receiver is in the lower right corner (in
landscape mode; in portrait mode, it is in the
lower left corner) of the screen bezel behind a
small hole.
Remove the obstruction.
Contact your installer or service provider.
m40L/m46L Installation Guide
Explanation / Further Action
Make sure the correct source is
selected by pressing
SOURCE
necessary, change to a different
source.
Make sure the source is on.
Make sure the cable between the
source and the display is correctly
connected at both ends.
If the screen is still a solid color, see
"Where to Go From Here" on
page 88.
The source is displaying a solid
color or a test pattern.
Reconnect cable or turn on unit.
Possible Resolution
.
If