Configuring An M40L/M46L - Planar m40L Installation Manual

Configuring an
m40L/m46L
After you select the picture source, most of the remaining setup is automatic,
although you can override the automatic settings and adjust them manually.
The source picture - from computer, video, DVD player - is not always perfect in its
size or resolution; it does not always conform exactly to a standard. The display can
compensate for this.
You'll find it easier to configure your displays when you perform the steps in the
following order:
• Select the Source (Picture) (See "Selecting the Source" on page 19)
• Adjust the Input Levels (See "Adjusting Input Levels" on page 25)
• Adjust Frequency and Phase (See "Adjusting Frequency and Phase" on page 31)
• Select the Scale Mode (See "Scale Mode Settings" on page 33)
• Adjust the Sharpness (See "Sharpness Settings" on page 39)
• Check the Image Position (See "Adjusting Position" on page 41)
• Set up Tiling for the image on multiple displays (See "Tiling a Display" on page
43)
• Adjust Scaling and Cropping (See "Zoom and Viewport" on page 47)
• Color Balance the displays (See "Adjusting Color Balance" on page 51)
m40L/m46L Installation Guide 17