Adding Or Replacing An Expansion Card - Gateway E-1500 User Manual

www.gateway.com

Adding or replacing an expansion card

Remove the single screw that secures the front I/O panel to the case.
6
Rotate the I/O panel down until it faces the tabletop, then pull the I/O
7
panel and its cables away from the case. Note the location of the hole
through which the cables are threaded.
Thread the new I/O panel's cables through the hole in the case, then insert
8
the tabs in the bottom of the I/O panel into the slots in the front of the case.
Rotate the I/O panel up until its screw hole aligns with the screw hole in
9
the front of the case, then secure it to the case with the screw.
Reconnect the I/O panel's cables to the appropriate connectors on the
10
system board.
Insert the front bezel's cables through the hole in the case behind the
11
bezel, then snap the bezel back into place.
Reconnect the front bezel's power and LED cables to the appropriate
12
connectors on the system board.
Replace the side panel by following the instructions in
13
panel" on page 147.
To add or replace an expansion card:
Remove the side panel by following the instructions in
1
panel" on page 144.
If you are adding a new expansion card, go to the next step. If you are
2
replacing an expansion card, go to
Adding or replacing an expansion card
Screw
"Replacing the side
"Removing the side
Step 4.
159