Installing A Processor Heat Sink - QUANTA Rackgo X Series F03A Technical Manual

I H
NSTALLING ARDWARE
6. Repeat for the remaining heat sink.

Installing a Processor Heat Sink

1. Align the heat sink over the processor plate making sure the arrow marking the air
flow is pointing towards the rear of the node.
2. Align the screws with the screw posts on the mainboard.
3. Tighten the screw in a sequential order. See the following drawing.
Figure 2-32. Removing the Heat Sink
Figure 2-33. Installing the Heat Sink
I P H
NSTALLING A ROCESSOR
S
EAT INK
2-24