Node Front View - QUANTA Rackgo X Series F03A Technical Manual

A S
BOUT THE YSTEM

Node Front View

15
Table 5: Node Front View
N . I
O TEM
1 HDD tray
External mini-SAS
2
port
3 USB
4 Power button
5 Reset button
6 Sled release latch
Power LED
7
(Blue)
HDD activity LED
8
(Green)
Beep error LED
9
(Amber)
10 Debug header
11 NIC
12 VGA
1
14 13
Figure 1-5. Node Front View
Each HDD board can support up to 2 SAS/SATA HDDs
Tray is connected through an internal miniSAS and power cable to
Windmill MB SAS/SATA board
Supports up to 6 GB SAS connection (optional)
Standard USB 2.0 connector
Press less than four seconds to activate power management event.
Press longer than four seconds to activate a hard power off.
Press to perform a hard reset and begin executing the BIOS initializa-
tion code.
Press and hold to release the system sled.
Displays during power on state.
Blinking state indicates system ID event trigger. See Mainboard LEDs on
page 1-7.
Displays during activity on the motherboard's SATA hard drive inter-
faces. See Mainboard LEDs on page 1-7.
Provides PC speaker functionality by illuminating the LED in place of
the PC speaker audible tone. See Mainboard LEDs on page 1-7.
14-pin (shrouded), right-angled, 2mm pitch connector; supports hot
plugging for existing debug cards.
 Two 7-segment LED: displays firmware POST information and sys-
tem error codes.
 One RS-232 serial connector: provides console redirection.
 One reset switch: triggers system reset when pressed.

Designed with a notch for easy installation to avoid pin shifting.
10 Gb SFP + connectors (optional)
Provides interface for an external display (optional)
2
12 11 10
D
ESCRIPTION
S O
YSTEM VERVIEW
3 4
5
6
7
8
9
1-6