Equipment Handling Practices; Power And Electrical Warnings; System Access Warnings - QUANTA Rackgo X Series F03A Technical Manual

Equipment Handling Practices

Reduce the risk of personal injury or equipment damage:
Conform to local occupational health and safety requirements when moving and

lifting equipment.
Use mechanical assistance or other suitable assistance when moving and lifting

equipment.
To reduce the weight for easier handling, remove any easily detachable compo-

nents.
Never lift or move your system soley by the handle on the component.


Power and Electrical Warnings

CAUTION!
!
M
AKE SURE THE SYSTEM IS REMOVED FROM THE RACK BEFORE SERVICING ANY NON
T
HE BUS BAR CLIPS MUST BE DISCONNECTED FROM THE POWER SYSTEM INORDER TO FULLY SEPARATE THE SYS
TEM FROM THE POWER SOURCE
CAUTION!
!
T
O AVOID RISK OF ELECTRIC SHOCK
FROM THE RACK

System Access Warnings

CAUTION!
!
T
O AVOID PERSONAL INJURY OR PROPERTY DAMAGE
ACCESSING THE INSIDE OF THE PRODUCT
 Disconnect from the power source by removing the system from the rack.
 Disconnect all cabling running into the system.
 Retain all screws or other fasteners when servicing. Upon completion servicing, sercure
with original screws or fasteners.
CAUTION!
!
I
F THE SYSTEM HAS BEEN RUNNING
,
SINK PROCESSOR AND CHIPSET MAY BE HOT
CAUTION!
!
U
NLESS YOU ARE ADDING OR REMOVING A HOT
.
VICING
CAUTION!
!
T
O AVOID INJURY DO NOT CONTACT MOVING FAN BLADES
,
FAN DO NOT OPERATE THE SYSTEM WITHOUT THE FAN GUARD IN PLACE
.
,
DISCONNECT ALL CABLING FROM THE SYSTEM AND REMOVE THE SYSTEM
.
:
,
ANY INSTALLED COMPONENTS LINK HDD
,
THE FOLLOWING SAFETY INSTRUCTIONS APPLY WHENEVER
.
- ,
PLUG COMPONENT ALLOW THE SYSTEM TO COOL BEFORE SER
. I
F YOUR SYSTEM IS SUPPLIED WITH A GUARD OVER THE
.
P M
RECAUTIONARY EASURES
- .
HOT PLUG COMPONENTS
-
, ,
MEMORY MODULES HEAT
-
XII