IBM 6151 Maintenance And Service Manual page 410

Step 12
1. Look at the type and slot positions you recorded, and if any,
install the boards, adapters, and options you removed.
2. Unplug the external power cable from the outlet.
3. Install the top cover. If needed, see Section 4.
4. Set the power switch on the system unit to On.
5. Follow the instructions on the menus to run the System
Checkout. If needed, see page 2-17.
TESTING COMPLETE
Press Enter to continue.
DlAG-2
WERE YOU ABLE TO LOAD AND RUN THE "SYSTEM
CHECKOUT" AND DID THE "NO TROUBLE WAS FOUND"
MESSAGE DISPLAY?
NO If the same failure occurs, contact your service support
person, otherwise, go to "Problem Determination Procedure
PIC 0030" on page 3-0030-1.
YES This completes the repair.
3-9860-12 Service Manual