IBM 6151 Maintenance And Service Manual page 384

Step 14
1.
Set the power switch on the system unit to Off.
2. If any, look at the type and slot positions you recorded, then
install the boards and adapters you removed
3. Connect any connectors that are disconnected.
4. If removed, install the top cover. If needed, see Section 4.
5. Set the power switch on the system unit to On.
6. Run the System Checkout. If needed, see page
2-17.
TESTING COMPLETE
Press Enter to continue.
DiAG-2
WERE YOU ABLE TO LOAD AND RUN THE "SYSTEM
CHECKOUT" AND DID THE "NO TROUBLE WAS FOUND"
MESSAGE DISPLAY?
NO Go to "Problem Determination Procedure PIC
0030"
on
page
3-0030-1.
YES This completes the repair.
3-8800-14 Service Manual