Before Starting The Engine For The First Time - Ransomes Mastiff 91 Operation And Maintenance Manual

7 OPERATION
8. Stop and inspect the equipment for damage immediately after striking an obstruction or if the machine
begins to vibrate abnormally. Have the equipment repaired before resuming operation.
Read the Safety Instructions.
7.4 BEFORE STARTING THE ENGINE FOR THE
FIRST TIME
1. Remove the sump filler plug (B) and with
the machine on level ground fill the sump
with a recommended engine oil up to the
base of the threads on the dipstick
(maximum level) of the filler plug.
NOTE: correct reading is obtained by replacing the
filler plug completely and removing it again. Replace
dipstick/filler plug after correct level of oil is obtained.
2. Remove cover from over gearbox and
clutch shaft by releasing screws (two
screws each side). Remove filler plug
(C) and fillgearbox with oil (See section
8.1) up to the level indicated on the
straight dipstick (supplied).
Replace plug when oil level is obtained.
3. Position the filler plug on the centre
section of the landlord between the rear
engine bearer and the main frame cross
stay. Remove filler plug (D) and fill
landroll with oil up to the level indicated
on the cranked dipstick (supplied).
Replace plug when correct level is
obtained.
4. Fill the petrol tank with unleaded petrol.
SAFETY, OPERATORS & MAINTENANCE MANUAL
Before you clean, adjust, or repair this
equipment, always disengage all drives,
lower implements to the ground, engage
parking brake, stop engine and remove
key from ignition switch to prevent
injuries.
B
Copyright Briggs & Stratton Corp. Used with Permission.
C
A
D
GB-25