List Of Drawings; Installation Drawings - Getinge 600 Series Installation Manual

LIST OF DRAWINGS

TABLE 6–1. INSTALLATION DRAWINGS
600 Series Roughing-In Drawing, Steam Sterilizer, 26 in. Single Door
600 Series Roughing-In Drawing, Steam Sterilizer, 26 in. Single Door w/Boiler
600 Series Roughing-In Drawing, Steam Sterilizer, 39 in. & 51 in. Single Door
600 Series Roughing-In Drawing, Steam Sterilizer, 39 in. & 51 in. Double Door
600 Series Roughing-In Drawing, Tables Document
600 Series Roughing-In Drawing, Notes Page
600 Series Roughing-In Drawing, Hold-Down Bracket Locations
600 Series Roughing-In Drawing, Seismic Anchor Information
600 Series Seismic Anchorage Calculations, Slab on Grade
600 Series Seismic Anchorage Calculations, Upper Floor

INSTALLATION DRAWINGS

INS 61301607027 Rev A US
For technical data, utility requirements, pertinent notes, and seismic
anchorage information, refer to the drawings listed in Table 6–1.
Title
NOTE
"SP" DRAWINGS SUPERCEDE "HS" DRAWINGS: Some special orders
have a roughing-in drawing specific to the sterilizer being installed. These
drawings are indicated by an "SP" prefix and are included in the manuals
package. If a sterilizer has an "SP" drawing, install the unit according to the
requirements listed on the "SP" drawing.
Figure 6-1 is the roughing-in drawing for the 600 Series Steam Sterilizer.
The content of each sheet is listed in Table 6–1.
Figure 6-2 is the seismic anchorage calculation for the 600 Series Steam
Sterilizer. Calculations for slab on grade and upper floor installations are
provided.
SECTION 6 DRAWINGS
Drawing No.
HS-4125 Rev. C
700601 Rev. A
Page No.
6–2
6–3
6–4
6–5
6–6
6–7
6–8
6–9
6–10
6–12
6–1