Removing The Sterilizer Front Panels - Getinge 600 Series Installation Manual

Packaging
REMOVING THE STERILIZER
FRONT PANELS
Operator Panel
(in raised position)
Notches
Prop Rod
3–4
To remove the front panels:
1. Refer to Figure 3–2. Use a screwdriver to turn the keyhole latch and
unlock the panels.
2. Unlatch the top panel, swing it open, and prop it open with the prop
rods found on the left and right sides of the panel.
3. Lift the left and right side panels off of the frame pins. The pins slide
through the slots on either side of the panels and lift out of the slot in
the lower panel.
4. Lift the bottom panel up off of the frame pins.
FIGURE 3–2. STERILIZER FRONT PANELS
Raise and latch
2
front panel (see detail).
Lift side panels
3
off frame pins.
Lift bottom panel
4
off frame pins.
Unlock latch
1
with screwdriver.
INS 61301607027 Rev A US
A07027-A2