Connections - Bosch DCN Next Generation Installation And User Instructions Manual

DCN NG | Installation and User Instructions | Section 2 | Interpretation Equipment
5.3

Connections

5.3.1 Introduction
This section gives an overview of typical system
connections using the channel selector:
• Connecting to the system (see section 5.3.2).
• Connecting the headphones (see section 5.3.3).
• Connecting extra headphones sockets (see
section 5.3.4).
• Connecting the output level reduction connector
(see section 5.3.5).
5.3.2 Connecting to the system
Use the DCN cable (see figure 5.2) to connect the
channel selector to the system. The DCN socket is used
to loop the channel selector through.
figure 5.4: Connecting to the system
Bosch Security Systems | 2004-03 | 9922 141 70521en
DCN
en | 42