Connections - Bosch DCN Next Generation Installation And User Instructions Manual

DCN NG | Installation and User Instructions | Section 2 | Interpretation Equipment
4.3

Connections

4.3.1 Introduction
This section gives an overview of typical system
connections using the interpreter desk:
• Connecting to the system (see section 4.3.2).
• Connecting a headset (see section 4.3.3).
• Connecting headphones (see section 4.3.4).
• Connecting external devices (see section 4.3.5).
4.3.2 Connecting to the system
Use the DCN cable (see figure 4.3) to connect the
interpreter desk to the system. The DCN socket is used
to loop the interpreter desk through.
figure 4.6: Connecting to the system
Bosch Security Systems | 2004-03 | 9922 141 70521en
4.3.3
On the left side of the desk, a headset can be connected
(see figure 4.2). The headset socket is intended for
IEC 268-11 compliant headsets with a 5-pole 180° DIN
connector.
figure 4.5: Headset socket
table 4. 1 : Headset socket details
Pin
1
2
3
4
5
DCN
Connecting a headset
3
5
2
Description
Microphone supply
Microphone in
Headphones out left
Headphones common
Headphones out right
en | 24
1
4