Mounting - Bosch DCN Next Generation Installation And User Instructions Manual

DCN NG | Installation and User Instructions | Section 4 | Installation Accessories
Technically, it was not possible to incorporate this diode
into the fiber interface because it is allowed to power a
significant part of the optical network from this external
power supply, with up to 5 A load. With a load of 5 A,
the power dissipation of the diode would be such that
the internal temperature of the fiber interface would
become too high. The diode should be specified for at
least 50 V reverse voltage and a maximum current
bigger than what can be expected from the connected
load.
Max. 48V/5A Max. 48V/5A
pin 2 pin 2
figure 19.4: Diode connection
Bosch Security Systems | 2004-03 | 9922 141 70521en
pin 1 pin 1
19.4

Mounting

The fiber interface can be mounted to a wall or any
other flat surface using a bracket. See figure 19.5 for
more information. The distance between the holes in
the bracket (d) is 40 mm.
figure 19.5: Mounting
Press the sides of the unit to snap it in and out of the
bracket.
en | 115