Table of Contents
Advertisement
6.2 Basic Settings of Checkers
Since each checker executes inspection in different ways, some of the provided parameters differ depending on
the checker. In this section, a common setting procedure is described.
6.2.1 Basic Procedure for Setting Checkers
Select a checker number and
1
checker.
2
Choose a camera image.
Configure the setting for
3
preprocessing
When selecting binary window, binary edge or feature extraction,
4
Setting of a slice level
5
Set an area
Set the conditions for each
6
checker
7
Implement a test
72
Specify a checker number from the checkers 1 to 99 and
select a checker.
We recommend that you assign 11 or larger numbers to
the checkers used for inspection and the numbers 1 to 10
to the checkers for adjustment and automatic adjustment
of an inspection area.
Select which camera image you want to use, Camera 1 or
Camera 2.
Preprocess the captured image for easy execution of the
desired inspection. 13 types of preprocessing are available.
You can combine up to 5 preprocesses, and save up to 5
groups for each product type.
Select one of the preprocess groups A to H and set upper
and lower values of a slice level.
Set an inspection area or "Mask" area, where the PV310
does not inspect, according to the inspection area as
necessary.
Configure the settings for the Area Size Adjustment
5-a
function, which can change an inspection area to fit
the object as necessary.
Set the items provided to each checker.
Confirm whether or not inspection is
performed as expected.
Page 73
Page 75
Page 76
Page 80
Page 82
Page 85
Refer to the appropriate
pages for each checker.
Refer to the appropriate
pages for each checker.
Advertisement
Table of Contents
