Table of Contents
Advertisement
6.18 Rotation Adjustment (Binary Edge Horiz., Binary Edge Vert.)
6.18.1 Setting Procedure
The way of detecting edges by Areas 1 and 2 and the setting procedure for edges are the same as those used for
"Binary Edge" (see page 96). Test execution for Areas 1 and 2 and the notices are described below.
Running a Test Using Areas 1 and 2
Before saving a base position, you can perform a test to check whether or not edges were detected in Area 1 or
Area 2. When a live image is currently displayed, import a new image first and begin the test. When a memory
image is displayed, run a test using the current memory image without capturing any images.
1.
Select "ROT. ADJ. (BIN.EDGE HORIZ.)" or "ROT. ADJ. (BIN.EDGE VERT.)"
2.
Press the A key while the tab or item under the tab is highlighted.
If no edge is detected, the following error code will appear in the message area.
E0044
Check to make sure that the error code above does not appear or that the edges were detected.
Different Condition for Each Area
Different condition to detect an edge can be set for area 1 and area 2. However, the following items must be set
the same.
•
Camera
•
Preprocess
•
Position Adjustment
Set the width of the Areas 1 and 2 as the same as possible.
It is advisable to minimize the width value as much as possible.
154
Advertisement
Table of Contents
