Run And Setup Modes; About Setup And Run Modes; Switching Between Run Mode And Setup Mode - Panasonic MICRO-IMAGECHECKER PV310 Use Manual

4.2 RUN and SETUP Modes

4.2.1 About SETUP and RUN Modes

RUN Mode:
This is a mode of performing inspection. The PV310 starts in this mode when you turn it on
the PV310 accepts various kinds of signals including inspection start signals (START signal) from external device.
In addition, in this mode, the inspection results can be output to the external device according to the
communication and output conditions. You cannot set or change the settings for product type, configuration data,
etc., which are configured with the keypad. In RUN mode, the menu bar is not displayed.
SETUP Mode:
This is a mode in which you can configure or change the settings for all the options in the menu bar (TYPE,
CHECKER, TOOL, ENVIRONMENT, CARD, and INFO.) All the external signals including the inspection start
signal (START signal) but excluding key emulation signal from external device are denied. Press the A key on the
keypad to perform a test, but the results will not be output to the external device. In SETUP mode, the menu bar
appears. For example, the figure shown on the previous page is a screen in SETUP mode, (because the menu
bar is displayed.)
*1
The product types that are displayed when you turn the PV310 on are the ones that have been selected
before the device is turned off.

4.2.2 Switching between RUN Mode and SETUP Mode

Press the C key to switch between the two modes.
(You can switch from SETUP mode to RUN mode only if the SETUP window is not displayed.)
If you cannot switch the modes by pressing the C key, the modes are locked using a password. In this case, keep
pressing the C key for more than one second so that the "Password" window is displayed. Enter your password to
switch the modes.
See page 223 for protecting the setting data by password.
*1
. Only in RUN mode,
47