Table of Contents
Advertisement
6.21 Rotation Adjustment (360 Degree Detection)
6.21.1 Setting Procedure
The way of detecting edges by Areas 1 and 2 and the setting procedure for edges are the same as those used for
"Smart Matching" (see page 113). In this section, the functional differences between Rotation Adjustment
(Matching Detection Angle) checkers and Smart Matching checkers and instructions for test execution are
described below.
The Items That cannot be Set with This Feature
With the Position Adjustment (Rotation Adjustment (360 deg. detection)) function, you cannot set the following
items.
•
Subtraction setting (Subtraction can not be performed.)
When there are Multiple Objects Fulfilling the Conditions
Be sure to sort the objects. After doing this, the first sorted object is detected. Sorting can be performed in the
descending/ascending order of area, x coordinate and y coordinate. If you do not sort the objects, the PV310
cannot detect the object which comes first, resulting in an unstable inspection. Refer to page 117 for the sorting
function.
Running a Test
Before saving a base position, you can perform a test to check whether or not objects were detected. When a live
image is currently displayed, capture a new image first and begin the test. When a memory image is displayed,
run a test using the current memory image without capturing any images.
1.
Select "ROT. ADJ. (360 DEG.DETECT.)".
2.
Press the A key while the tab or the item is highlighted.
If no edge is detected, the following error code will appear under the judgment results in the message area.
E0044
Check to make sure that the error code above does not appear or that the edges were detected.
160
Advertisement
Table of Contents
