General - Getinge 600 Series Installation Manual

GENERAL

INS 61301607027 Rev A US
The 600 Series Steam Sterilizers are designed to sterilizer and dry (where
applicable) typical healthcare and laboratory goods. The sterilizers will
include pressure pulse gravity steam, pressure vacuum pulsing, and liquids
cycles. These sterilizers are NOT intended for use other than expressly
stated.
The sterilizers are designed with a number of built-in safety devices. To
avoid injury, it is very important that these safety devices are not bypassed
and/or disabled.
CAUTION
DAMAGE TO EQUIPMENT: Follow the instructions in this manual to ensure
the safe and efficient performance of the sterilizer. Failure to comply with
these instructions or to provide specific services could void the warranty.
AUTHORIZED SERVICE REPRESENTATIVE
• Read all instructions thoroughly before installation.
• Installation and service work must be performed by qualified personnel
trained on this sterilizer.
• The sterilizer must be operated by personnel who are knowledgeable
about the sterilizer operation and are trained on its use.
• Personnel must receive regular periodic training on the operation and
maintenance of this equipment in accordance with established
procedures for the workplace.
ELECTRICAL SAFETY
• Switch off the electric power before opening the electrical components.
The components contain the following voltage:
Control Box
Power Box
Boilers
• Before welding begins on or close to the sterilizer, all wiring connected
by plugs and sockets must be disconnected from all circuit boards of
the control system.
SECTION 2 SAFETY
24 Vac
115 Vac
208, 240, 480, or 600 Vac, Three-Phase
2–1