When Using The Battery Pack - Casio DT-X5 Series User Manual

Before Getting Started

When Using the Battery Pack

Charging is required when using the battery pack (HA-A20BAT or DT-5025LBAT) sold
separately.
Use the Dual Battery Charger when charging the battery pack before installing in the
Handheld Terminal, or use the Cradle-type Battery Charger or Cradle to charge after
installing in the Handheld Terminal.
1. Remove the alkaline battery holder if it is installed.
Refer to page 32 for information on removing the alkaline battery holder.
2. Use the Dual Battery Charger when charging the battery pack in advance.
Refer to page 65 for information on the charging procedure.
3. Load the battery pack into the Handheld Terminal.
1 Slide the two main battery cover lock
switches on both sides of the Handheld
Terminal to the "FREE" position, and
then remove the main battery cover.
2 Load a battery pack (HA-A20BAT) or a
large-capacity battery pack (DT-
5025LBAT).
• Take care that the battery pack is
oriented correctly when you load it.
• Install the battery pack so that the
battery pack removal tape is on top
of the battery pack.
E-20
2
1
1
1
2