Setting The Oven Function; Changing The Temperature; Fast Heat Up Function - AEG PROCOMBI PLUS BS7304001 User Manual

12 www.aeg.com

6.3 Setting the oven function

1. Activate the appliance with
The display shows the set temperature,
the symbol and the number of the oven
function.
2. Touch
function.
3. Touch
automatically after five seconds.

6.4 Changing the temperature

Touch
temperature in steps of 5 °C.
When the appliance is at the set
temperature, an acoustic signal sounds
three times and the Heat up indicator
goes out.
6.5 Checking the temperature
You can see the temperature in the
appliance when the function or
programme operates.
1. Touch
The Temperature / Time display shows
the temperature in the appliance.
2. Touch
temperature or the display shows it
automatically after five seconds.

6.6 Fast heat up function

Do not put food in the oven when the
Fast heat up function operates.
The Fast heat up function is not available
with every oven function. An acoustic
signal sounds if the Fast heat up function
is not available for the set function if
Faulty tone is activated in the "Settings
menu".
or to set an oven
or the appliance starts
If you activate the appliance
and do not set an oven
function or programme, the
appliance deactivates
automatically after 20
seconds.
or to change the
.
to go back to the set
The Fast heat up function decreases the
heat up time.
or .
To activate the Fast heat up function
touch and hold
seconds.
If you activate the Fast heat up function,
the bars on the display
one and
the function operates.
6.7 Steam cooking
The water drawer cover is in the control
panel.
WARNING!
Do not put water directly
into the steam generator!
Use only water as the liquid.
Do not use filtered
(demineralised) or distilled
water.
1. Press the cover of the water drawer
to open it.
2. Fill the water drawer with 800 ml of
water.
The water supply is sufficient for
approximately 50 minutes.
3. Push the water drawer to its initial
position.
4. Activate the appliance.
5. Set the steam function (refer to the
"Oven functions" table) and the
temperature.
6. If necessary, touch
DURATION
(refer to "Setting the END" or
"Setting the DURATION").
The first steam shows after
approximately 2 minutes. An acoustic
signal sounds when the appliance is at
approximately the set temperature. The
signal sounds again at the end of the
cooking time.
7. Touch
signal and the appliance.
When the steam generator is
empty, an acoustic signal
sounds.
for more than three
flash one by
comes on to show that
to set the
or END function
to deactivate the acoustic