4 . Select Finishing .
5 . Touch Corner .
NOTE: System is defaulted
to Corner Staple in the
upper left corner so no
additional programming
is necessary.
6 . Touch OK .
7 . Touch Program .
8 . Touch any key labeled
Not registered .
9 . Touch New .
10 . Input Job Name 1:2 .
11 . Touch OK and Close .
From the Copy screen
Press the "Reset" Key
before beginning the
following exercise.
To retrieve Job
12 . Insert multi-page
document on the dual Scanner .
13 . Touch Program .
14 . Touch 1:2 (Pre-Programmed Job) .
15 . Touch recall .
16 . Touch Start .
Press the "Reset" Key before beginning the following exercise.
40