Operations - Bissell POWERGLIDE CORDLESS 1534 SERIES User Manual

Operation s
PowerBrush switch
1. Press the button with brush bar icon to run
the PowerBrush.
2. The PowerBrush will not run when vacuum
is locked in upright position
3. If debris is keeping the vacuum from
operating, turn off power switch, remove
debris, and then turn power switch on to
resume vacuuming.
NOTE: Turn off the PowerBrush when
vacuuming hard surfaces, such as hard
wood or tiled floors, as well as when cleaning
smaller rugs that may be caught by the
rotating brush (see section Operate
PowerGlide Cordless
Power Mode Switch
1. Press the button with the double line icon to
switch between high and low power modes.
2. High power mode is useful for cleaning high
traffic areas.
Above floor cleaning
1. Twist diverter swtich to horizontal position
to direct suction to the vacuum hose.
2. Push down on the handle release button
and pull the handle and extension tube out
of the body.
3. The 2‑in‑1 accessory can be attached to the
end of the extension tube.
4. The extension wand can be removed by
pressing the release button and pulling it off.
The 2‑in‑1 accessory can also be attached to
the handle end.
5. The portable canister vacuum can be released
by pressing the button on the back
of the body and pulling away from the foot.
6. The canister vacuum can be carried around
for easy cleaning of heard to reach areas.
www.BISSELL.ca
6
for additional details).
TM
WARNING
Before using your vacuum, make sure that the dirt
container is in locked position and that the fi lter is in
place. DO NOT operate your vacuum without the fi lter.
1.
2.
Tip
» Before cleaning under low furniture, check area
first for objects that might harm the unit or block
the vacuum hose.
1.
3.
5.
2.
4.
6.