How To Configure Packet Filter On P-660Hw-Tx V3 - ZyXEL Communications P-660HW-Tx v3 Support Notes

P-660HW-Tx v3 Series Support Notes
Need to perform save after this by command „wan atm vchunt save‟
(3) Delete items from the auto-haunting preconfigured table by useing
command:
wan atm vchunt remove <remote node> <vpi> <vci>

14. How to configure packet filter on P-660HW-Tx v3?

The P-660HW-Tx v3 allows you to configure up to twelve filter sets with six
rules in each set, for a total of 72 filter rules in the system. You can apply up to
four filter sets to a particular port to block multiple types of packets. With each
filter set having up to six rules, you can have a maximum of 24 rules active for
a single port.
The packet filter function on P-660HW-Tx v3 is the same as before, just that
you could only configure the filter set and apply them by command in CLI. It‟s
very complex for common users to do it. So here‟s the recommendation:
(1) Usually if you want to block special packets, you could edit a firewall rule in
Web Configurator.
79
All contents copyright © 2008 ZyXEL Communications Corporation.