ZyXEL Communications P-660HW-Tx v3 Support Notes page 80

(2) By factory default, ZyXEL has preconfigured many filter sets for your
reference, you can check them by command:
sys filter set index [set#] [rule#]
Usage: set#: 1~12; rule#: 1~6. Commonly the preconfigured filter sets are as
follows: <set 2, rule 1~6>, <set 3, rule 1>, <set 4, rule 1>.
sys filter set display
For example:
This could satisfy mostly requirement. You could select any of them to apply to
the WAN node or LAN Interface on demand. The command is as follows:

Apply to WAN node:
wan node index <node#>
Usage: node#= 1~8, corresponding to the remote node 1~8
wan node filter <incoming|outgoing> <tcpip|generic> <set1#> <set2#>
<set3#> <set4#>
Usage: You can apply at most four filter sets to one remote node.
wan node save

Apply to LAN Interface:
lan index [index#]
Usage: index#=1 main LAN
2 IP Alias#1
3 IP Alias#2
All contents copyright © 2008 ZyXEL Communications Corporation.
P-660HW-Tx v3 Series Support Notes
80