Table of Contents
Advertisement
(4) Basically the zero configuration only work on the VC that was preconigured
in the auto-haunting preconfigured table.
15. How could I configure triple play on P-660HW-Tx v2?
The common triple play scenario is as follows:
VOIP Telephone
Video Client
Clients surfing
Other clients
Triple Play is a port-based policy to forward packets from different LAN port to
different PVCs, thus we could assign different parameters to the PVC (CBR,
UBR, VBR-RT, VBR-nRT) to guarantee different applications.
We could configure triple play on P-660HW-Tx v2 via CLI. The command is:
sys tripleplay set <EportID> <PVCID>
For example: sys tripleplay portbase set
sys tripleplay portbase set
sys tripleplay portbase set
sys tripleplay portbase save
The traffic from Ethernet port 1 must be forwarded to PVC1, vice versa.
The traffic from Ethernet port 2 must be forwarded to PVC2, vice versa.
The traffic from Ethernet Port3 must be forwarded to PVC3, vice versa.
16. How to configure packet filter on P-660HW-Tx v2?
The P-660HW-Tx v2 allows you to configure up to twelve filter sets with six
rules in each set, for a total of 72 filter rules in the system. You can apply up to
four filter sets to a particular port to block multiple types of packets. With each
filter set having up to six rules, you can have a maximum of 24 rules active for
a single port.
All contents copyright © 2006 ZyXEL Communications Corporation.
0/32
Port1
PVC1
0/34
Port2
PVC2
0/55
Port3
PVC3
1/32
Port4
PVC4
ATUR
CPE
P-660HW-Tx v2 Series Support Notes
Port1
Port2
Port3
Port4
IP-DSLAM
VL-Switch
Access Network
1 1
2 2
3 3
VOIP Server
IPTV Server
Internet
Others
ISP
83
Advertisement
Table of Contents
