Installing The Touch Unit; Display The Installation Pattern - Epson BrightLink 475Wi Installation Manual

8 Installing the Touch Unit

The following procedures must have been completed before installing the Touch Unit:
•
Installing the projector (see page 30)
•
Adjusting the projected image (see page 41)
•
Calibrating the interactive pen(s)
s Refer to your projector User's Guide or Start Here folder for detailed instructions.
❏
There are magnets built in to the back of the Touch Unit. Typically, the Touch Unit
should be installed by attaching the magnets to the screen or whiteboard.
❏
If the magnets cannot be attached, use commercially available M4 screws (×3).
❏
Install the Touch Unit on a flat, smooth, unwarped surface that is the same level
surface as the screen surface. If there is unevenness on the screen surface of more
than 0.2 inches (5 mm) in any direction, your fingers may not be detected and
finger touch operations may not be performed correctly.
Follow the steps below to install the Touch Unit and connect to the projector. Some menus may differ slightly
from the illustrations, but the installation instructions are the same.
Caution
The Touch Unit should only be connected to the BrightLink 595Wi/595Wi+ or BrightLink Pro
1430Wi models. Do not connect the Touch Unit to any other projectors or devices.
A
Turn on the projector
Using the Remote Control
BrightLink 595Wi/595Wi+
B

Display the installation pattern

1. Select Easy Interactive Function from the Extended menu.
Using the Remote Control
BrightLink Pro 1430Wi
49
Using the Control Panel