Control Pad - Epson BrightLink 475Wi Installation Manual

Touch Unit
The following parts are packaged with your projector and are necessary when attaching the Touch Unit. When
installing the Touch Unit on a non-magnetic surface, you will also need three M4 screws.
Touch Unit and markers
(markers are inside the unit)
Touch Unit connection cable

Control Pad

The following parts are packaged with your projector and are necessary when attaching the Control Pad.
When installing the Control Pad on a wall, you will also need four M4 × 20 mm screws.
Control Pad
Label (×4)
Tape (approx. 2.4 inches
[6 cm]) for securing the
markers (×12)
AA size batteries (× 2)
9
Spacer for screw hole (×3)
Infrared deflector (approx.
11.2 inches [28.5 cm]) (×8)
Rubber feet Port protection
stickers