Installing The Touch Unit - Epson Brightlink 695Wi+ Installation Manual

3 Installing the Touch Unit

Before installing the Touch Unit, make sure you install the projector and adjust the projected image (see the
Installation Guide included with your projector mount). You also need to calibrate the interactive pen(s) before
you install the Touch Unit (see the printed documentation included with your projector or the online User's
Guide for more information).
The steps for installing the Touch Unit vary depending on where you are installing the Touch Unit:
•
If you are installing the Touch Unit above the frame of a whiteboard, see "Installing the Touch Unit above a
whiteboard" on page 11.
•
If you are installing the Touch Unit on a whiteboard, see "Installing the Touch Unit on a whiteboard" on
page 27.
❏
If the distance from the wall to the surface of the whiteboard is greater than
2 inches (51 mm), you must install the Touch Unit on the whiteboard.
❏
If the frame of the whiteboard extends more than 0.1 inch (3 mm) away from the
board surface, you must install the Touch Unit on the whiteboard.
Caution
The Touch Unit should only be connected to the BrightLink 695Wi/695Wi+/696Ui/697Ui/710Ui
or BrightLink Pro 1450Ui/1460Ui/1470Ui models. Do not connect the Touch Unit to any other
projectors or devices.
10