Edit Mode; Enable Edit; Delete A Scene; Delete A Step Or Steps - Chauvet Stage Designer 50 User Manual

5. E M
DIT ODE

Enable Edit

Delete a Scene

Delete a Step
or Steps
Insert a Step or
Steps
Modify a Step
or Steps
Page 12 of 21
In order to make any changes to the steps in a scene or scenes, Edit must be enabled.
To enable Edit:
1. Enable Record.
2. Press the <MODE SELECT / REC SPEED> button until the red indicator LED for
Chase◄►Scene lights up.
3. Use the <PAGE / REC CLR> button to select the page to which the desired scene is
saved.
4. Press and hold the <EDIT / ALL REV> button, and tap the flash button (<13 / 37>–
<24 / 48>) of the desired scene.
5. Release <EDIT / ALL REV>. The selected scene LED will light up, indicating the
product is in Edit mode.
To exit Edit:
1. Press and hold the <RECORD / SHIFT> button.
2. Tap the <ADD KILL / REC EXIT> button. All Channel LEDs will flash.
3. Release <RECORD / SHIFT>. The controller will be back in Record mode.
To delete a single entire scene, do the following:
1. Enable Edit for the scene to be deleted.
2. Press the <DELETE / REV ONE> button three times.
To delete one or multiple steps within a saved scene:
1. Enable Edit for the scene to be edited.
2. Use the <STEP> button to cycle through the steps of the scene until the desired step
is selected.
3. Press the <DELETE / REV ONE> button once to delete the selected step.
4. Repeat steps 2 and 3 until all unwanted steps have been deleted.
5. Continue editing, or exit Edit.
To insert a steps or steps into a previously saved scene:
1. Enable Record and record the step or steps you wish to be inserted.
2. Enable Edit for the scene into which you wish to insert the new step or steps.
3. Use the <STEP> button to cycle through the steps of the scene. Select the step you
wish to be after the inserted step or steps.
4. Press the <INSERT / % or 0-255> button to insert the new step or steps before the
selected step. All Channel LEDs will flash.
5. Continue editing, or exit Edit.
To modify an existing step within a previously saved scene.
1. Enable Edit for the scene to be edited.
2. Use the <STEP> button to cycle through the steps of the scene until the step to be
edited is selected.
3. Press and hold either:
·
The <DOWN / BEAT REV> button if you wish to lower a value.
or
·
The <UP / CHASE REV> button if you wish to raise a value.
4. Tap or hold the <FLASH> button of the channel you wish to edit. Tapping will change
the value by 1 at a time. Holding will cause the value to rise or fall smoothly.
5. Repeat steps 2, 3, and 4 until all desired modifications have been made.
6. Continue editing, or exit Edit.
Moving the channel faders in Edit mode has no effect on the recorded scene. The
changes will not be saved.
Stage Designer 50 User Manual Rev. 10