Physical Fader Assignment - Chauvet Stage Designer 50 User Manual

Physical Fader
Assignment
Page 16 of 21
This feature allows the user to change the DMX output assigned to a fader. For example,
the user can make fader 3 (which normally only outputs DMX channel 3) output any or all
DMX channels they wish.
If two different fixtures have the same function (such as red LED output), but must be
assigned different DMX addresses, the user can combine the desired channels of both
fixtures into one fader channel. Moving that fader will then cause both DMX values to
change at the same time.
To alter the physical fader assignments, do the following:
1. Press and hold the <RECORD / SHIFT> button.
2. While holding <RECORD / SHIFT>, press the <6 / 30> flash button three times.
3. Release <RECORD / SHIFT>.
4. Press the <FLASH> button of the DMX channel you wish to assign to a different
fader.
5. Press and hold <RECORD / SHIFT>.
6. While holding <RECORD / SHIFT>, press the <FLASH> button of the fader you wish
to assign.
7. Release <RECORD / SHIFT>.
8. Repeat steps 1–3 until the desired assignments are set.
9. Press and hold <RECORD / SHIFT> and the <ADD KILL / REC EXIT> button to exit
the mode.
Example:
To change fader 1 to output DMX channel 9:
1. Press and hold the <RECORD / SHIFT> button.
2. While holding <RECORD / SHIFT>, press the flash button <6 / 30> three times.
3. Release <RECORD / SHIFT>.
4. Press the <9 / 33> flash button.
5. Press and hold <RECORD / SHIFT>.
6. While holding <RECORD / SHIFT>, press the <1 / 25> flash button.
7. Release <RECORD / SHIFT>.
All physical faders can be re-assigned to output on multiple DMX channels. There is no
limit to the amount of channels that can be assigned to a single fader. If desired, up to all
48 channels of DMX output can be assigned to a single fader.
Stage Designer 50 User Manual Rev. 10