When Copying Onto Ohp Transparencies - Ricoh VD0107571 Operating Instructions Manual

F
Enter the horizontal size of the paper (Horiz.) with the number keys, and
then press the {OK} key.
G
Enter the vertical size of the paper (Vert.) with the number keys, and then
press the {OK} key.
The "
Programmed
H
Place the originals, and then press the {Start} key.
I
When the copy job is finished, press the {Clear Modes} key to clear the set-
tings.
Note
❒ If you make a mistake in step
enter the value again.
Reference
p.23 "Loading Paper on the Bypass Tray"

When Copying onto OHP Transparencies

When copying onto OHP transparencies, select [OHP (Transparency)] in Paper
Type.
Important
❒ OHP transparencies must be loaded face down in the tray with the notched
corner of the sheet in the appropriate corner of the tray.
❒ To prevent multiple sheets from being fed at once, fan OHP transparencies
before placing them on the tray.
❒ Remove copied sheets from the Internal Tray one by one.
A
Select [Byp.] using {U} or {T}.
B
Load OHP transparencies face down on the bypass tray.
C
Press the {q} key.
" message appears.
F
or
Copying from the Bypass Tray
G , press the {Clear/Stop} key, and then
2
27