Matrox ATC RG-200DL User Manual page 8

Step-by-step connection setup
WARNING:
warm to the touch. Make sure your unit is located in a well ventilated area and nothing is
blocking its ventilation holes.
Connect your unit to your
1
interface card
To connect your ATC RG unit to your
interface card, you need a dual LC optical
cable (sold separately).
Connect one end of your optical cable to the
optical connector of your interface card.
Connect the other end of your cable to the
optical connector on your unit. Make sure
your connectors are properly connected.
Note:
cable supported by your Matrox product is
250 meters/750 feet. For more
information,
page
Connect your monitors
2
ATC RG-400SL – Connect your monitors to
the monitor connectors at the back of your
ATC RG unit.
If your monitors have DVI connectors,
connect them directly to the monitor
connectors at the back of your unit.
If your monitors have HD-15 connectors,
you need DVI-to-HD15 adapters to connect
your monitors to the monitor connectors on
your unit.
8 Matrox RG Series – User Guide
Because the body of your ATC RG unit is used to disperse heat, it may become
The maximum length of optical
see "Product information",
12.
Cable A
Cable B
Optical cable
Cable B
Monitor
connector (DVI)
DVI-to-HD15
adapter
Monitor connector
(HD-15)
Cable A