Matrox ATC RG-200DL User Manual page 10

Connect your audio devices
5
(optional)
Your unit has 2 input and 2 output audio
connectors. The 2 input connectors are
(
in
output audio connectors are
( ) and
connectors support stereo jack connectors.
The
Line out
plug optical connectors.
To connect an audio device to your unit:
a Plug one end of your audio cable into the audio connector on your unit.
b Plug the other end of the cable in your audio device. For information on the type of
connector supported by your audio device, see its documentation.
Note:
connector at the back of the unit is muted.
Your Matrox product is now installed. Restart your computer, and install your Matrox software.
Verifying your interface connection
To check your interface connection, your computer and your ATC RG unit must be on.
On the bracket of your interface card, make
sure both the transmission (
reception (
If the reception indicator is red and you have
separate optical cables, switch the cables in
the optical connector of your Matrox
product.
If the transmission indicator is red, your
optical connector may be loose. Make sure
your optical connector is firmly in place by
pushing it into its housing. If the light doesn't change to green, contact your Matrox
representative.
10 Matrox RG Series – User Guide
) and (
Microphone
Headphones
( ). All audio
Line out
connector also supports SPDIF (Sony/Philips Digital Interface Format) mini-
If you're using the headphone connector at the front of your unit, the line-out
) and
TX
) indicator lights are green.
RX
Line
). The 2
Transmission indicator light
Reception indicator light
Audio connector
(SPDIF/Stereo)
Optical connector