Setting The User Bit - Canon XA25 Instruction Manual

Setting the User Bit

The user bit display can be selected from the date or the time of recording, or an identification code
consisting of 8 characters in the hexadecimal system. There are sixteen possible characters: the
numbers 0 to 9 and the letters A to F. When you record a scene, the user bit will be recorded with it.
The user bit is also output from the HD/SD-SDI terminal (
Operating modes:
1 Open the user bit [Setting] screen.
> >
[FUNC.] [MENU]
• To set the time for the user bit, select [
[ Date]. In such case, the rest of the procedure is not necessary.
• The user bit setting screen will appear with the orange selection frame on the leftmost digit.
• To reset the user bit to [00 00 00 00], touch [Reset] and then touch [X].
• Touch [Cancel] to close the screen without setting the user bit.
Í] or [Î
2 Touch [ ] to change the digit as necessary.
3 Touch another digit you want to change.
4 Change the rest of the digits in the same way.
5 Touch [OK] and then touch [X].
NOTES
• When playing back MP4 movies, the user bit embedded in the signal output from the HD/SD-SDI
terminal ( only) and HDMI terminal will have a value of 0 and cannot be changed.
> >
[User Bit Type] [
Time] instead; to set the date for the user bit, select
Setting the User Bit
only) or HDMI terminal.
Setting]
77