Canon XA25 Instruction Manual page 150

Appendix: Menu Options Lists
• When [OLED Dimmer] is set to on, the camcorder's screen will automatically become dimmer if the
camcorder is left without any operation for 3 minutes. Operate any control on the camcorder to
return the screen to its previous setting.
[OLED Mirror Image]:
when you rotate the OLED panel 180 degrees toward the subject. In other words, the screen will show
a mirror image of the subject.
150
[OLED Color Balance]:
and [R] (red) bars by touching [+] and [-]. You can check the results on the screen.
[VF Brightness]:
the screen brighter if it is difficult to see.
[Notification Sounds]:
• While pre-recording (A 91) is activated, the camcorder will not emit any notification sounds.
[Wireless Remote Control]:
[Tally Lamp]:
Activates the tally lamp when the camcorder is recording, the wireless controller is being
operated, the battery level is low or a memory card is full. When set to [j Off], the tally lamp will not
turn on in these cases. The tally lamp is located on the handle unit so make sure you attach it to the
camcorder in advance.
[Powered IS Button]:
(A 63).
[Î Press and Hold]: Powered IS will be activated while you hold the button pressed down.
[Ï Toggle On/Off]: Each press of the button will turn the Powered IS function on and off.
[Set WB Priority]:
current white balance and the white balance setting selected for [Set WB Priority].
[Focus/Zoom Ring Direction]:
[Focus/Zoom Ring Response]:
ring.
[Focus Preset Speed]:
[Battery Info]:
When you are using a battery pack that is compatible with Intelligent System, this option
displays a screen where you can verify the battery charge (as a percentage) and the remaining
recording time (
• If the battery pack is exhausted, the battery information may not be displayed.
[HDMI Time Code]:
camcorder's time code.
[HDMI Status]:
Displays a screen where you can verify the standard of the output signal from the HDMI
OUT terminal.
[Output Onscreen Displays]:
on the screen of a TV or monitor connected to the camcorder.
[Distance Units]:
setting also affects units for GPS information when using the optional GP-E2 GPS Receiver.
When set to [i On], this function reverses the image on the screen horizontally
Allows you to adjust the color balance of the OLED screen. Adjust the [B] (blue)
Sets the viewfinder screen to one of two brightness levels. You can use this to make
A beep will accompany some of the camcorder's operations.
Allows the camcorder to be operated with the wireless controller.
Determines the operation mode of the assignable button set to [È Powered IS]
You can press an assignable button set to [Ä WB Priority] to switch between the
Changes the direction the focus/zoom ring needs to be turned.
Selects the sensitivity of the response when operating the focus/zoom
Determines the speed at which the focus changes to the preset position.
mode) or playback time (
When set to [i On], the HDMI signal output from the camcorder includes the
When set to [i On], the camcorder's onscreen displays will appear also
Selects the units to use for the focusing distance display while focusing manually. This
mode).