Fujitsu PRIMERGY BX620 S4 Operating Manual page 43

Installation and Operation
Connecting a CD-ROM drive and floppy disk drive to the server blade via USB
Ê Connect the breakout cable to the USB/VGA port on the front of the relevant
server blade
Ê Connect the data cable of the CD-ROM drive and, if required, also the floppy
disk drive to the USB ports of the breakout cable (see
Ê Make sure that the basic unit is switched on.
Ê To switch the server blade on, press the On/Off button on the control panel
(position 2 in
Ê If the CD-ROM drive and the floppy disk drive are not supplied with power
via the USB ports of the breakout cable, connect them directly to the mains.
Ê Connect the monitor, keyboard and mouse to the KVM blade on the rear of
the basic unit. For information see the BX600 S2 or BX600 S3 basic unit
operating manual (see
Ê Press the KVM button (position 4 in
of the server blade to switch the keyboard, mouse and the monitor of the
KVM blade to the server blade.
Preparing the Software
Booting from the CD-ROM drive
Boot the relevant server blade from the ServerStart CD to install the operating
system. In some cases this may require that you change a few settings:
Ê Insert the ServerStart CD in the CD-ROM drive and press the On/Off button
(position 2 in
Ê Press the KVM button (position 4 in
of the server blade to switch the keyboard, mouse and the monitor of the
KVM blade to the server blade. Wait a few seconds for the monitor to be
activated.
Ê When prompted, press [F2] to call up the BIOS setup of the server blade.
Ê In the BIOS setup menu select the Boot submenu and enable Boot from CD-
ROM Drive.
Ê Press [ESC] twice and select Exit Saving Changes from the Exit menu.
Once the server blade has booted from the ServerStart CD, the startup screen is
displayed.
BX620 S4
(figure 6 on page
figure 7 on page
"Related Publications" on page
figure 7 on page
Operating Manual
Configuring the BX620 S3 Server Blade
36).
38).
figure 7 on page
38) on the control panel of the server blade.
figure 7 on page
figure 6 on page
75).
38) on the control panel
38) on the control panel
36).
43