Fujitsu PRIMERGY BX620 S4 Operating Manual page 10

Features
– 4 Gbit/s Fibre Channel I/O module (PCIe), enables transfer rates of 1, 2 or 4
Gbit/s and supports multiple FC storage subsystems with the corresponding
versions.
I
This I/O module can only be operated in a BX600 S3 basic unit with
an FC Switch Blade Brocade SW-4016 D4. For more information, see
the operating manual for the BX600 S3 basic unit.
– Gigabit Ethernet I/O module (PCI-X)
– Gigabit Ethernet I/O module (PCIe), additionally supports TOE (TCP/IP
Offload Engine) and iSCSI
– 10 Gbit Ethernet I/O module (PCIe)
I
This I/O module can only be operated in a 10-Gbit Switch Blade 10/2.
For more information, see the operating manual for your basic unit.
To use the additional I/O functionality, at least one Fibre Channel pass-thru
blade or switch blade, or an Ethernet pass-thru or switch blade, must be
installed in slot NET3 of the basic unit.
I
You cannot mix different I/O modules in a PRIMERGY BX600 S2 or
BX600 S3 basic unit.
How to install I/O modules later is described in the Options Guide.
Graphics Controller
The BX620 S4 Server Blade has a 16 MB onboard ATI ES1000 graphics
controller. A monitor can be connected via the VGA port (via breakout cable) on
the front of the server blade or via the KVM blade at the back of the basic unit.
Accessible Drives
Accessible drives (e.g. floppy disk or DVD drives) can be connected via the two
USB ports (via breakout cable) on the front of the server blade while the system
is running.
High Availability and Data Security
When memory data is accessed, 1-bit errors in the main memory are recog-
nized and automatically corrected with the ECC (Error Correcting Code)
method.
10 Operating Manual
Introduction
BX620 S4