Fujitsu PRIMERGY BX620 S4 Operating Manual page 32

Installing the BX620 S3 Server Blade
V
ATTENTION!
Keep the dummy module for future use. If a server blade is removed
again and not replaced with a new one, the dummy module must be
reinstalled because of cooling, fire protection and EMC regulations.
Install the dummy module in the same way as the server blade (see
Installing the Server Blade
V
ATTENTION!
Make sure you observe the safety notes and the information on
handling electrostatic-sensitive devices in the section
Electrostatic-Sensitive Devices" on page
Server blade boots automatically after installation in a switched-
on BX600 S3 basic unit with management blade S3.
If you insert a BX620 S4 server blade into a switched-on BX600 S3
basic unit with management blade S3, the server blade will automat-
ically perform a POST (Power-On Self-Test) and then switch itself off.
You may not switch off the server blade during the automatic boot
process!
If the BX600 S3 basic unit is switched off when the server blade is
installed, the POST will be performed automatically after the basic
unit is switched on.
32 Operating Manual
Installing the Hardware
"Modules with
24.
page 32).
BX620 S4