The ice cube maker will begin to pro‐
duce ice cubes again as soon as this
new drawer has been placed in position
and closed properly.
Altering the size of the ice cubes
The size of the ice cubes produced de‐
pends on the volume of the water in‐
take which you can set according to
your requirements.
Setting the water volume
The size of the ice cubes produced de‐
pends on the water pressure present
and the water intake time which has
been set for the ice cube maker. If the
ice cube maker is only producing small
ice cubes the water pressure is low. In
order to produce larger ice cubes, the
water intake time for the ice cube mak‐
er needs to be prolonged. The volume
is set at the factory to medium (E3).
The setting can only be selected if
the ice cube maker is switched on.
Touch the settings sensor.
All symbols available for selection will
appear in the display and the symbol
flashes.
Touch the sensors for setting the
temperature (or ) repeatedly until
the the ice cube maker symbol
flashes in the display.
Touch the OK sensor to confirm your
selection.
Making ice cubes
By touching the and sensor you
can now alter the water volume:
0: the ice cube maker is switched off
1: the ice cube maker is switched on
2: set the water volume
3: select the ice cube tray cleaning
position
4: rinse the ice cube maker
Touch the OK sensor to confirm your
selection.
By touching the or sensor, you
can now set the water volume you re‐
quire (E1 to E8):
E1: low water volume
E8: high water volume
Touch the OK sensor to confirm your
selection.
The selected setting is applied.
Touch the settings sensor to leave
settings mode, or
Close the appliance door.
Otherwise the appliance will switch to
normal operation after approximately
one minute.
51