Altering The Size Of The Ice Cubes; Setting The Water Volume - Miele KFN 37692 iDE Operating And Installation Instructions

Making ice cubes
If you require a large amount of ice
cubes,
^ replace the full ice cube drawer with
the drawer beside it on the right.
The ice cube maker will begin to
produce ice cubes again as soon as
this new drawer has been placed in
position and closed properly.

Altering the size of the ice cubes

The size of the ice cubes produced
depends on the volume of the water
intake which you can set according to
your requirements.

Setting the water volume

The size of the ice cubes produced
depends on the water pressure present
and the water intake time which has
been set for the ice cube maker.
If the ice cube maker is only producing
small ice cubes the water pressure is
low. In order to produce larger ice
cubes, the water intake time for the ice
cube maker needs to be prolonged.
The volume is set at the factory to
medium (E3).
The setting can only be selected
when the ice cube maker is
switched on.
^ Touch the settings sensor.
All symbols available for selection
appear in the display and the 0 symbol
flashes.
54
^ Touch the sensors for setting the
temperature (X or Y), repeatedly until
the ice cube maker symbol ®
flashes.
^ Touch the OK sensor to confirm your
selection.
^ By touching the X or Y sensor, you
can now alter the water volume:
0: the ice cube maker is switched off
1: the ice cube maker is switched on
2: set the water volume
3: select the ice cube tray cleaning
position
4: rinse the ice cube maker
^ Touch the OK sensor to confirm your
selection.
^ By touching the X or Y sensor, you
can now set the water volume you
require (E1 to E8):
E1:
low water volume
E8:
high water volume
^ Touch the OK sensor to confirm your
selection.
The selected setting is applied.
^ Touch the settings sensor to leave
settings mode,
or
^ Close the appliance door.
Otherwise the appliance will switch to
normal operation after approximately
one minute.