Miele KFN 37452 iDE Operating And Installation Instructions page 56

Cleaning and care
The Rinsing setting can only be se‐
lected when the ice cube maker is
switched on and the water container
has been filled.
 Touch the settings sensor.
All symbols available for selection will
appear in the display and the  symbol
flashes.
 Touch the sensors for setting the
temperature ( and ) repeatedly
until the ice cube maker symbol 
flashes in the display.
 Touch the OK sensor to confirm your
selection.
 By touching the  and  sensor,
you can now select the setting you
want:
0:the ice cube maker is switched off
1: the ice cube maker is switched on
2: set the water volume
3: select the ice cube tray cleaning
position
4: rinse the ice cube maker
 Touch the OK sensor to confirm your
selection.
The selected setting is applied. The
symbol in the display for the ice cube
maker  and the indicator light on the
ice cube maker will flash while the ice
cube maker is being rinsed.
You will hear the ice cube tray turn so
that it is at an angle.
 Wait until the ice cube tray has com‐
pleted this rotation before continuing.
56
The ice cube maker will then switch off.
The ice cube maker symbol  will go
out.
 Carefully remove, the ice cube draw‐
er, which will be full of water. Empty
and clean it.
The ice cube tray cannot be removed
and must be cleaned in situ.
 Dry the ice cube tray  with a soft
cloth.
When the ice cube maker is switched
back on again, the ice cube tray will
rotate back into the original position.