Miele KFN 37452 iDE Operating And Installation Instructions page 26

The correct temperature
The following information shows in the
display while the sensors are being
touched:
– Touching a sensor once: the last
temperature selected flashes.
– Each subsequent touch of the sen‐
sor: adjusts the temperature shown
in 1 °C steps.
– Leaving a finger on the sensor
changes the temperature continuous‐
ly.
Approximately 5 seconds after the last
time a sensor has been touched, the
current temperature inside the appli‐
ance is automatically shown.
Or
 Touch the OK sensor to confirm your
selection.
26
If you have adjusted the temperature,
wait for approx. 6 hours if the appli‐
ance is not very full and for approx.
24 hours if the appliance is full before
checking the temperature display, as it
will take this long for the appliance to
give an accurate reading.
 If, after this time, the temperature is
still too high or too low, you will need
to adjust it again.
Temperature range
The temperature can be adjusted:
– in the refrigerator section from 1 °C
to 9 °C
– in the freezer section from -15 °C to
-26 °C.