Typical Applications - Master Appliance PH-1100K Instruction Manual

Operating Instructions
The proper amount of heat for
each application is dependent
upon the distance of the noz-
zle from the work surface and
the length of time that heat is
applied to the work surface.
Before performing any appli-
cation, we recommend that
you experiment with a piece of
scrap material. Use care in
approaching the work until
you find the proper combina-
tion of heat adjustment con-
trol, distance from the work
surface, and the heat applica-
tion time.
Use a gentle back and forth
motion when applying heat
unless it is found that a con-
centrated heat is desired.

Typical Applications

Shrink Packaging
Use low or high heat
Shrink Tubing
Use low or high heat
To Operate Heat Gun
1) Plug heat gun into properly
rated outlet.
2) Move rocker switch to "Hot"
position. Heat gun will
come up to operating tem-
perature in approximately
two minutes.
3) Move switch to "Off" position.
Strip Paint
Use low or high heat
Bend PVC Tubing
Use high heat
5
CAUTION: Do not place unit
on its side while using
spreader or heat shrink
attachments.
Install Vinyl
Use low or high heat
Dry Film
Use low heat