Typical Applications - Master Appliance Proheat PH-1200 Instruction Manual

Operating Instructions
The proper amount of heat for
each application is dependent
upon the distance of the
nozzle from the work surface
and the length of time that
heat is applied to the work
surface.
Before performing any
application, we recommend
that you experiment with a
piece of scrap material. Use
care in approaching the work
until you find the proper
combination of heat
adjustment control, distance
from the work surface, and the
heat application time.
Use a gentle back and forth
motion when applying heat
unless it is found that a
concentrated heat is desired.

Typical Applications

Shrink Packaging
Use low or high heat
Shrink Tubing
Use low or high heat
To Operate Heat Gun
1) Plug heat gun into properly
rated outlet.
2) Move rocker switch to "Hot"
position. Heat gun will
come up to operating
temperature in
approximately two minutes.
3) Move switch to "Off" position.
Strip Paint
Use low or high heat
Bend PVC Tubing
Use high heat
5
CAUTION: Do not place unit
on its side while using
spreader or heat shrink
attachments.
Install Vinyl
Use low or high heat
Dry Film
Use low heat