Credit Card Reader; External 12 Vdc Power Supply - Elo TouchSystems 1529L User Manual

Credit Card Reader
There is a USB credit card reader only. The USB version is available in HID and Key‐ board emulation versions.
The reader reads all three stripes on a standard credit card or drivers license.
Reference Standards‐Conform to
applicable standards
Message Format
Card Speed
MTBF Electronics
Two Port USB Hub
The Hub provides 2 internal USB ports to be used by the credit card reader and the touchscreen. The hub also
supplies two USB ports to the outside of the back of the 1529L for external use. The hub is only used by the USB
version of the 1529L. The hub meets the following requirements:
Specification Full compliance with USB specification 1.0, 1.1 and 2.0 and HID Class Definition Rev 1.0.
Hub shall be self powered Hub shall provide 2 external and 4 internal downstream ports with individual port
over current detection, protection and recovery. Supports both Open Host Controller Inter‐ face (OHCI) and
Universal Host Controller Interface (UHCI). Supports Suspend and Resume operation. Bus fault detection and
recovery.
External Power Supply
The 1529L shall be powered by a universal AC power source or 12 VDC from external
power source. The power supply shall provide the following capability: AC power: Input voltage 90 to 264 vac
Input frequency 47 to 63hz
DC power: Input voltage 12 vdc
Input line and load regulation +/‐2%
International Standards Organization, American National Standards
Institute, California Drivers License, American Association of Motor
Vehicle Administrators
ACCII
3 to 50 IPS
125,000 hrs; Head 1,000,000 passes