System Management Submenu - NEC EXPRESS5800 LC1400 series User Manual

System Management Submenu

Feature
Sever Management Info
System Event Logging
Clear Event Log
EMP Password switch
EMP Password
EMP ESC Sequence
EMP Hangup Line
String
Modem Init String
High Modem Init String
EMP Access Mode
EMP Restricted Mode
Access
EMP Direct
Connect/Modem Mode
Choices Description
Press ENTER Refer to "System Management Info
Submenu."
Disabled When enabled, system events will be
Enabled logged by BIOS and BMC.
No Yes clears the system event log (SEL) in
Yes BMC.
Disabled Enables EMP password.
Enabled
[A...Z, 0 9] This field only shows up when EMP
password is enabled.
Refer to Appendix
B.
Refer to your
modem
documentation.
Refer to your
modem
documentation.
Refer to your
modem
documentation.
Pre-boot Only Pre-boot Only - EMP is only enabled
during power down through power up to
the end of POST. Com 2 is returned to
system use at the end of Post when
operating system boots.
Always Active Always Active - EMP is always enabled.
Com 2 cannot be used by operating
system. It is now dedicated for EMP use.
Disabled - EMP is disabled. Com 2 is
Disabled always available for system use by
console redirection or operating system
Disabled If set to Enabled, Power on/off and Reset
Enabled server controls via EMP are no longer
available.
Direct Connect Sets how EMP connects to the server.
Modem Mode Direct Connect means a null modem
serial cable directly connects COM 2
connector port to the EMP console
machine.
Modem mode indicates that a modem is
connected on COM 2 for EMP use.
Your Setting
Configuring Your System 3-13