GREAT PLANES Proud Bird Instruction Manual page 16

❏
6. The recommended O.S. motor includes 3mm female bullet
connectors which must be soldered onto the recommended
Castle Ice 75A ESC. This speed control will also require you
to solder a battery connector to the battery leads. If you are
using the recommended battery, you will need W.S. Deans
Male Ultra Plug (WSDM1302).
❏
7. Make a 6" [152mm] long strap to hold the ESC in place
from the included hook and loop material by cutting a length
and overlapping the mating ends by 1/2" [13mm]. Connect
the ESC to the motor and route the receiver lead through
the hole in the fuselage former. A 6" [152mm] servo lead
extension is required. Be sure to use tape, heat shrink tubing
or a special clip made for securing servo lead extension
connectors together.
❏
8. Use a piece of self-adhesive hook and loop material or
make a strap from non-adhesive hook and loop material to
secure the receiver in the location shown.
❏
9. Cut the included 2" [51mm] piece of plastic tubing into
two equal pieces. Glue the pieces to hold the 2.4GHz receiver
antennas in the orientation described in your radio manual.
❏
10. Coat the center of the battery tray with a thin coating
of epoxy to improve the adhesion of the self-adhesive hook
and loop material. Medium or thick CA glue will also work.
Allow the glue to harden completely before attaching pieces
of the hook side from self-adhesive hook and loop material.
16